Select the In-Sight ISXXXX CC-B version from the Hardware Catalog, and add that to your configuration, recompile and then download.This will make it easier to restore the same IO address to the new CC-B version. Tip: Cognex recommends to take a screen shot of the IO module address of the existing In-Sight vision system/sensor before deleting it. Go into the Siemens HW Config tool and delete the vision system from the PROFINET I/O system. When you upgrade an In-Sight vision system's firmware version to 5.8.0 or later and if the vision system has PROFINET enabled and the V2.34 GSD file is used, follow these steps: *The In-Sight 57C vision systems do not support Conformance Class B and V2.34 GSD. Uses the original Conformance Class A PROFINET stack. The Class B configs are suffixed with CC-B, indicating that the config is Class B (for example, In-Sight IS2XXX CC-B).ĥ.7.x or earlier and In-Sight 5705/5705C vision systems Supports Conformance Class B (newer PROFINET stack). Please use the appropriate GSD file based on your vision system model and its firmware version.ĥ.8.0 or later, except In-Sight 5705/5705C vision systems* The In-Sight Explorer software contains below GSD files.
0 Comments
Leave a Reply. |